Lite’G Castor Oil Finishing Spread Pomade


My youngest daughter, Lauren, was just not having any more of being the guinea pig to test my products, so I had to step up to the plate. I mixed up a light (Lite’G) spread pomade to use for dry-twist/braid styles and flat-ironing for 4A and 4B hair. My goal was to make a product that didn’t end up feeling sticky on the hair, but is able to achieve great finished styles.

IMG_2521

Bantu Knot product test

I call it a “spread” because it’s not as heavy as a butter or cream, but it melts in your hands and is easy to spread on the hair in small amounts. I am very pleased with the weightlessness of the product in my hair. I have a bantu knot in the bang area now, and I am psyched at how it turned out!

 

Ingredients

1 tablespoon castor oil

1 tablespoon safflower oil

1 teaspoon emulsifying wax (trial-size available)

1 teaspoon Brahmi Herb Mix (see below for recipe)

 


 

Brahmi Herb Mix 

1 teaspoon brahmi powder (trial-size available)

¼ cup water

 

To Make

Use a ratio of 1/4 cup of water to 1 teaspoon of the dried herb powder. Pour boiling water over herbs and allow to steep 2 hours or until cool in a closed container. Strain herbs with a coffee strainer and discard. Use remaining liquid.


 

Lite’G Castor Oil Finishing Spread 

To Make

Make brahmi herb mix in a separate pot and let cool to warm. Mix castor and safflower oils with the emulsifying wax in another pot in a small double boiler. When the water in the bottom pot of the double boiler reaches the boiling point, the emulsifying wax will dissolve in the castor and safflower oils, about 1 minute. Remove castor and safflower oil from the heat and place on a potholder. Immediately combine the warm brahmi herb mix with the hot grapeseed oil (If you do it the other way around you will lose oil) in a 2-cup capacity container and use a wire whisk to blend 2-3 minutes. The mix should be a creamy consistency at this time. Allow the mix to cool to room temperature and then refrigerate. Use immediately.

To Use

I recommend blowing out hair with  Low-Heat Protection Lotion. To achieve the bantu knot look, apply the castor oil finishing spread in a pea-sized amount or smaller to thin sections of hair and pass over with a flat-iron no more than 2 times. Then spray lightly (do not saturate) with a holding spray or alcohol-free hair spray and twist and wind the hair into a bantu knot. Allow knots to set overnight. Unwind, separate, and style the hair.

Caution

The liquids in the recipe are at scalding temperatures. Mixolo’G, Natural Hair Mixology is not responsible for the assumption of risk in the execution of this recipe.

IMG_2539

Finished mixed textures look

I would love your feedback on this recipe! ❤ Ally